This document contains the list of Top Services Topics for VNX, identified by EMC Support as the most trending topics for the month of May 2019:
It is recommended that you also check for important information such as advisories (ETAs, ESAs), and other key resources on the “Support by Product” pages on the EMC Online Support portal.
Requirements for LUN Migration in VNX array.
A Data Mover panic occurred when performance statistics commands were used.
By default, NFSv3 is the active NFS service on the VNX. Customer didn't enable NFSv4 on the VNX
The backup of the replication destination can only be done through a checkpoint in some customer environments. If the backup is configured directly on the destination file system without NDMP checkpoints, the backup will be aborted when a replication transfer finishes.
Multiple pools may be offline due to the virtual provisioning feature is in degraded state.
These stack traces are simply a follow up indication of quota exceeded. It is safe to ignore.
In Unisphere Service Manager (USM), when trying to add a DAE ( Hardware--> Hardware Installation--> Install Disk Array Enclosure), the page with the bus selection does not appear and after clicking next, in the page where the cables should be connected, the DAE add is failing
Only Storage Pool Auto-Delete policy is enabled by default. The policies for Pool LUNs, Consistency Groups, and VNX Snapshots are disabled by default.
Updated version of libssh2.so file needed for use with RecoverPoint/SE.
Some VNX Software products use Java. Oracle has changed the licensing requirements for Java. This article answers the most common questions about the effect of these changes on the use of the VNX software.
Note: Please click “Follow” at the top right of this screen (when logged in) to receive update notifications.