Unsolved
1 Rookie
•
5 Posts
0
576
VNX 5300 reinstallation and access
Hello, what can I do if I have a username and password but no IP address for the device? I can't even see the IP address with network discovery.
Unsolved
1 Rookie
•
5 Posts
0
576
Hello, what can I do if I have a username and password but no IP address for the device? I can't even see the IP address with network discovery.
Top
DELL-Josh Cr
Moderator
Moderator
•
8.5K Posts
0
May 30th, 2023 06:00
Hi,
Thanks for your question. These are the default IP addresses.
SP-A: 128.221.1.250 (Service LAN port on SP-A SAN Management Module)
SP-B: 128.221.1.251 (Service LAN port on SP-B SAN Management Module)
Let us know if there is anything else that we can help you with.
DELL-Josh Cr
Moderator
Moderator
•
8.5K Posts
0
May 31st, 2023 13:00
https://dell.to/3IPiz6u do the procedure for install, and the service lan procedure and management software here. https://dell.to/3IONwYk
Nipeko
1 Rookie
1 Rookie
•
5 Posts
0
May 31st, 2023 13:00
ohh i see, if I have a serial port and an RJ 12 connection, how will my device use the storage space. Does it not require special software?
Nipeko
1 Rookie
1 Rookie
•
5 Posts
0
September 19th, 2023 20:45
@DELL-Josh Cr
Thank you :)
Hi,
After resetting the management port, you can see the IP address, the VNX launcher is also installed, but I cannot access it through the browser. Do you have any idea what the problem might be? (Advanced IP Schanner already sees it)
Nipeko
1 Rookie
1 Rookie
•
5 Posts
0
September 20th, 2023 07:25
@DELL-Josh Cr,
Yes, this software was installed using the installation guide, but unfortunately it is still not available. don't I have to press the button again to reach it ?
(edited)